FTDI USB-RS232-WE-1800-BT Cable, USB-RS232-WE USB to RS232 Serial Cable,1.8M, Wire END (5V)

USB-RS232-WE-1800-BT_ 5.0 is an USB to RS232 levels serial UART converter cable with 1.8 m cable length and 5V power supply output. It incorporates FT232RL USB to serial UART interface IC which handles all the USB signalling and protocols. The cables provide a fast, simple way to connect devices with a RS232 level serial UART interface to USB. It contains a small internal electronic circuit board, utilising the FT232R, which is encapsulated into USB connector end of cable. The integrated electronics also include the RS232 level shifter plus Tx and Rx LEDs which give a visual indication of traffic on the cable.

The other end of the cable is bare, tinned wire ended connections by default. The USB side of the cable is USB powered and USB 2.0 full speed compatible. The cable supports the FTDIChip-ID, with a unique USB serial number programmed into the FT232R. The USB to RS232 cables require USB drivers, which are used to make the FT232R in the cable appear as a virtual COM port (VCP).

UHCI / OHCI / EHCI host controller compatible.
Visual indication of Tx and Rx traffic via LEDs in the transparent USB connector.
Fully assisted hardware (RTS#/CTS#) or X-On / X-Off software handshaking.
Internal EEPROM with user writeable area.
Data transfer rates from 300 baud to 1 Mbaud.
USB 2.0 Full Speed compatible.
USB-RS232 converter cable provides a USB to RS232 serial interface with customised end connectors.
FTDIs royalty-free VCP allow for communication as a standard emulated COM port and D2XX direct drivers provide DLL application programming interface.
Support for FT232R FTDIChip-ID feature for improved security.
Entire USB protocol handled by the electronics in the cable USB.
EIA/TIA-232 and V. 28/V. 24 communication interface with low power requirements.
Low USB bandwidth consumption.
-40°C to +85°C operating temperature range.